Industrial radiant heater Bilux P 2000 ( Single Phase Supply)
Designed for : For heating industrial premises with high ceilings. It is possible to use both the main heating system and the zone heating of workplaces: heating workshop, production, car showroom, garage.
The P 2000 model is often used in rooms with a ceiling height of 3-4 meters. The higher the ceiling, the more profitable it is to use Bilux heating compared to traditional heating.
Effect on the human body: Bilux P series radiators are long-wave infrared heaters, so they can be used in rooms where people stay for a long time. It has a beneficial effect on the human body.
Technical features Bilux P2000
- Power consumed – this is the parameter of electricity consumption per hour of operation of the heater. The data may vary depending on the thermal insulation of the room.
- The radiant heater’s maximum efficiency is obtained by installing it on the ceiling parallel to the floor, it can also be installed at an angle, but it should not be more than 30 degrees.
- The heater does not start operating temperature immediately, this may take 10-20 minutes after being turned on. Warming up of the room also does not occur immediately, it can take from 30 minutes upwards depending on the outside temperature.
WARNING: the heating plate becomes red hot to 300 degrees Celsius! Don’t touch while in operation, and you wont see the glow. -
Industrial radiant heater Bilux P 4000 ( 3 Phase Supply)
Purpose : for heating rooms with high ceilings (up to 20 meters). Often used as the main heating system, it can also be used as additional heating for work areas.
The P4000 is often used in rooms with a ceiling height of 4-20 meters, such as heating a car showroom, workshop, production, garage, gym.
Effect on the human body: Bilux P series radiators are long-wave infrared heaters, so they can be used in rooms where people stay for a long time. It has a beneficial effect on the human body.
Technical features Bilux P4000:
- Power consumed – this is the parameter of electricity consumption per hour of operation of the heater. The data may vary depending on the thermal insulation of the room.
- The radiant heater’s maximum efficiency is obtained by installing it on the ceiling parallel to the floor, it can also be installed at an angle, but it should not be more than 30 degrees.
- The heater does not start operating temperature immediately, this may take 10-20 minutes after being turned on. Warming up of the room is also not immediate, it can take from 30 minutes upwards depending on the outside temperature.
- WARNING: the heating plate becomes red hot to 300 degrees Celsius! Don’t touch while working!
How to control the temperature in the room? We advise always use thermostats. , your Electrician can supply these from any local Electrical hardware outlet, either wired or wireless.
Important! Even if you have already encountered such radiators, trust the selection of our specialists. This way you will save time and we will get a satisfied customer!
